User's Manual

Page 12
3. Legal Information
FCC Statement:
Any device incorporating this module must include an external, visible, permanent marking or label
which states: “Contains FCC ID: 2ACARSG500M2”
The SG500M2-X modular transmitter is only FCC authorized for the specific rule parts (i.e., FCC
transmitter rules) listed on the grant, and that the host product manufacturer is responsible for
compliance to any other FCC rules that apply to the host not covered by the modular transmitter grant of
certification.
The final host product still requires Part 15 Subpart B compliance testing with the modular transmitter
installed.
15.21
You are cautioned that changes or modifications not expressly approved by the part responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
1) this device may not cause harmful interference and
2) this device must accept any interference received, including interference that may cause undesired
operation of the device.
This module has been tested and found to comply with the following requirements for Modular
Approval.
 Part 2.1046 – Measurements required: RF power output
 Part 22H – Cellular radiotelephone service
 Part 24E – Broadband PCS
 Part 27C – Technical standards
 Part 90S – Regulations governing licensing and use of frequencies in the 806-824, 851-869,
896-901, and 935-940 MHz Bands, 851-869, 896-901, and 935-940 MHz Bands
 PART 96—CITIZENS BROADBAND RADIO SERVICE
FCC RF Exposure:
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with a minimum distance of 20