Installation Guide

129
TREX
®
SIGNATURE™ RAILING
9. For post-to-post
configuration, fasten
upper rail to each
bracket by installing
screws diagonally
through upper rail into
bracket using two self-
tapping screws each
side (provided with
bracket kit).
10. For crossover post
configuration, fasten
upper rail to crossover
post by installing screws
diagonally through
upper rail into post using
two self-tapping screws
each side (provided with
bracket kit).
NOTE: Pre-drilling is recommended (7/64" [2.8 mm]
drill bit) for attachment of railing to bracket.
11. Attach upper rail cover to upper rail by aligning
cover on one side of rail. Then, starting from one end
of rail, snap cover onto opposing slot working down
length of rail. GENTLE tapping with a rubber mallet
may facilitate fastening.
Attachment of Bracket Covers, Skirts, and Caps
12. Attach corresponding
bracket covers over
opening in upper and
bottom rails.
13. Attach provided post
skirt to bottom of
posts when using Trex
®
Signature™ posts.
14. Attach post caps to Trex
®
Signature™ posts (use
of rubber mallet may be required for secure
attachment).
15. Attach post caps to post sleeves using external
grade PVC construction adhesive.
16. For crossover post
configuration, attach
crossover post cap to
crossover post.
HOW TO INSTALL PANELS/CONTINUED
TREX
®
SIGNATURE™
1
11
3
2
1
14
Trex
Signature
post
®
™
2
Post
sleeve
15
3
1
1
13
Trex
Signature
post
™
®
2
1
2
12
16
2
10
1
7/64"
(2.8 mm)
7/64"
(2.8 mm)
2
9
1
7/64"
(2.8 mm)
7/64"
(2.8 mm)