Installation Guide

115
TREX
®
SIGNATURE™ RAILING
ATTACHING CROSSOVER SWIVEL BRACKET ON TREX
®
SIGNATURE™
POST/
CONTINUED
TREX
®
SIGNATURE™
6. Determine location/height of the stair crossover
swivel bracket by aligning the angle of this with
the fixed brackets (or compound swivel
brackets) already installed (posts can be cut if
necessary).
7. Once location/height is determined, center and pre-
drill two holes (using a drill bit slightly smaller than
that of self-tapping screw diameter) on opposite sides
of post, approx. 1/4" (0.6 cm) from top of post. Drill
through the post and into the stair crossover swivel
bracket on each side.
NOTE: Slightly contersink pre-drilled holes to allow for
flat head screw to seat flush on the post. This will allow
cover to fit over screw heads.
8. Attach stair crossover swivel bracket to post with
two self-tapping screws (provided). Slide cover over
post to hide screws.
6
X°
7
1/4"
(0.6 cm)
1/4"
(0.6 cm)
8
1
2