Installation Guide

97
TREX
®
SIGNATURE™ RAILING
Attach Upper Railings
13. Working from one end of upper rail, snap balusters
into upper rail working down length of rail. Fasten
center baluster into center slot using two #8 x 1-1/4"
(3.2 cm) screws (provided).
NOTE: Pre-drilling is required (7/64" [0.28 cm] drill bit)
for attachment of railing to bracket.
14. At post locations, fasten
upper rail to crossover
post by installing screws
diagonally through
upper rail into post using
two self-tapping screws
each side (provided).
NOTE: Pre-drilling is required (7/64" [0.28 cm] drill bit)
for attachment of railing to bracket.
15. Attach “crowned" upper rail cover to upper rail
by aligning cover on one side of rail. Then starting
from one end of rail, snap cover onto opposing slot
working down length of rail. GENTLE tapping with a
rubber mallet may facilitate fastening.
Attachment of Bracket Covers, Skirts, and Caps
16. Attach corresponding bracket covers over opening
in bottom rails.
17. Attach provided post skirt to bottom of posts when
using Trex
®
Signature™ posts.
18. Attach crossover post
cap to crossover post.
19. Attachment of Foot
Block.
See instructions on
page 104.
1
1
13
2
1
15
3
2
2
14
1
7/64"
(.28 cm)
7/64"
(.28 cm)
HOW TO INSTALL HORIZONTAL RAILING CROSSOVER POST TO
CROSSOVER POST/CONTINUED
TREX
®
SIGNATURE™
18
2
16
1
TrexSignature
post
17
Trex Signature™
post
®
2