Installation Guide

84
TREX
®
SIGNATURE™ RAILING
INSTALLING TREX
®
SIGNATURE™ POSTS AND/OR TREX
®
SIGNATURE™
CROSSOVER POSTS ON WOOD OR CONCRETE/
CONTINUED
3. Insert (2) stainless steel barrier strips under
mounting bolt holes. Use appropriate shims if
posts are not plumb. Attach posts using four
TREX SUPPLIED 3/8" x 3-3/4" (10 mm x 95 mm)
wedge anchors. Reference SKU part number
ALPOSTHWCONC for required hardware (wedge
anchors, washers, and nuts).
NOTES:
» When using hammer to tap anchors in place, keep
threaded nut at top of anchor in order to not damage
threads.
» Recommended torque for anchors is 20 ft-lbs.
3
BarrierBarrier
POST
SLEEVES
WILL
NEED TO
BE CUT
TREX
®
SIGNATURE™
RAILING CONFIGURATIONS
Cutting posts/post sleeves is NOT required.
A. Trex
®
Signature™ post, pressure-treated post or Trex Post Mounts* with Trex
Transcend post sleeves, or Trex Joist Mount Posts*
B. Trex
®
Signature™ top rail
C. Trex
®
Signature™ bottom rail
D. Trex
®
Signature™ balusters
See page 86 for “How to Install Standard Railing".
*NOTE: See specific installation instructions for attachment of Trex post mounts or Trex
Joist Mount Posts prior to installing any railing
.
Cutting posts/post sleeves is Not required.
A. Pressure-treated post, Trex Post Mounts* or Trex Joist Mount Post WITH Trex
Transcend post sleeves.
NOTE: » Trex® Signature™ Posts or Trex® Signature™ Joist Mount Posts cannot be
used.
B. 2" x 4" (51 mm x 102 mm) lateral top rail
C. Trex
®
Signature™ top rail
D. Trex
®
Signature™ bottom rail
E. Trex
®
Signature™ balusters
F. Trex
®
Signature™ Cocktail Rail Bracket**
See page 99 for “How to Install Trex® Signature™ Traditional Railing".
Post sleeves will need to be cut.
A. Pressure-treated post with Trex Transcend post sleeve
NOTE: » Only for use with 4" x 4" (102 mm x 102 mm) post sleeve.
» Trex
®
Signature™ Posts, Trex Post Mounts or Joist Mount
Posts cannot be used with Trex
®
Signature™ Cocktail design.
B. Deck board top rail. NOTE: Enhance (scalloped profile) and Escapes
cannot be used.
C. Trex
®
Signature™ top rail
D. Trex
®
Signature™ bottom rail
E. Trex
®
Signature™ balusters
F. Trex
®
Signature™ Cocktail Rail Bracket**
See page 98 for “How to Install Signature Cocktail Railing".
A
B
C
D
A
B
D
C
E
F
A
B
D
C
E
F
Standard
Cocktail
Traditional
** Trex
®
Signature™ Cocktail Rail brackets (sold separately) are for use with either Trex
®
Signature™ Traditional or Trex
®
Signature™ Cocktail
designs. For a 6' section, use 4 brackets and screws provided, for 8' section, use 5 brackets and screws provided.