Installation Guide

73
TRANSCEND RAILING
HOW TO ATTACH COCKTAIL STYLE GLASS PANEL RAILING/CONTINUED
TREX TRANSCEND
12. Secure deck board
to Universal rail with
2" (51 mm) pan head
screws (not provided)
approximately every
16" (406 mm) on center
at an angle. (DO NOT
overtighten. Attach from
underside of railing into
bottom of decking board.)
13. Place inverted Universal
rail with deck board
attached onto RSB’s
with glass panel in
the channel. Attach
Universal rail to RSB’s
with three self-tapping
screws provided (use
three outer holes; do
not use hole in RSB that
is closest to post). If two hole bracket is included,
attach with two self-tapping screws (provided).
14.
Attach Deck Board
to post (ensure that
screws are attached
to wood post) with
Trex recommended
composite screws
(quantity of 2 per each
board end).
15.
Attaching Panel Support Moldings
See instructions on page 71.
16-17.
Hiding Brackets
See instructions on page 71.
18.
Installing Foot Block
Attach foot block per detailed instructions.
12
1
1
13
2
3
Hole
RSB
2
2
Hole
RSB
14
NOTES: Read all instructions BEFORE installation.
» You must purchase the 1/4" (6 mm) tempered glass
panels. See dimensions below.
» Glass panels Only for use with maximum 6'
(1.83 m) on center post spacing.
» NOT recommended for stair applications.
HOW TO ATTACH TRADITIONAL STYLE GLASS PANEL RAILING
TREX TRANSCEND
TEMPERED GLASS PANEL DIMENSIONS
» 36" (914 mm) high rail:
1/4" x 30" x 63-1/2" max.
(6 mm x 762 mm x 1613 mm)
» 42" (1067 mm) high rail:
1/4" x 36" x 63-1/2" max.
(6 mm x 914 mm x 1613 mm)