Installation Guide

70
TRANSCEND RAILING
HOW TO INSTALL ROUND OR SQUARE ALUMINUM BALUSTERS/CONTINUED
TREX TRANSCEND
10. Snap baluster spacer
into bottom rail. Place
inverted baluster
spacer on top of first
baluster spacer.
Attaching Balusters
11. Working at slight
angle, press baluster
through both baluster
spacers and into bottom
aluminum baluster
adaptor strip, ensuring
balusters are tight. Once
balusters are seated
into aluminum baluster
adaptor strip on bottom
rail, maneuver baluster into upper rail aluminum
baluster adaptor strip. Some force will be needed to
press balusters into place and level them.
TIP: Ensure balusters are level prior to attempting to
slide baluster spacer up. This will allow for the baluster
spacer to move up freely and snap into upper rail. Use
of a rubber mallet to gently tap balusters in level is
recommended.
12. Slide baluster spacer up
and snap into top rail.
Place optional top rail
gaskets on each end of
rail.
10
2
12
HOW TO INSTALL STANDARD GLASS PANEL RAILING
TREX TRANSCEND
NOTES: Read all instructions BEFORE installation.
» You must purchase the 1/4" (6 mm) tempered glass
panels. See dimensions below.
» Glass panels ONLY for use with maximum 6' (1.83 m)
on center post spacing.
» Not recommended for stair applications.
2
1
11
NOTE: Construction methods are always improving. Please refer to www.trex.com for the most up-to-date installation requirements.