Instructions / Assembly

7b. Lift secured railing
section up, and CENTER
t
his section in between the
spanned posts on pre-
positioned support blocks.
NOTE: To help stabilize railing
section use a quick-grip clamp
(or other type of clamp) and
clamp the first baluster to post
sleeve. (DO NOT OVERTIGHTEN CLAMP.)
7c.
Install both bottom and top brackets on each side to post
using two #8-10x2" wood screws (provided).
Attaching
Post Caps and
Installing Foot Block
8.
Secure post caps with
silicone or PVC adhesive.
Attach foot block per foot
block instructions.
NOTE: Clean up any excess
adhesive before it dries.
Have Questions? NOTE: Construction methods are always improving. Please ensure you
1–800–BUY–TREX have the most up-to-date installation instructions by visiting: trex.com TEHR-0720
TREX ENHANCE
®
HORIZONTAL RAILING
(Also Applies to Trex Select
®
Railing)
Installation Instructions
7b
HOW TO INSTALL STANDARD HORIZONTAL RAILING/CONTINUED
TREX ENHANCE
®
7c
2
8
1
HOW TO INSTALL COCKTAIL RAILING
TREX ENHANCE
®
A
B
D
C
E
Cocktail
Important: O NLY use with pressure-treated 4 x 4 post
(3.5" nominal square) and 4" x 4" post sleeve. Trex Post
M
ounts or Joist Mount Posts cannot be used with Enhance
Cocktail railing.
1.
Installing Pressure-Treated Posts, Post Sleeve Skirts and
Post Sleeves
See instructions on page 2.
Cutting Post and Post Sleeve
2. Mark and cut post and post
sleeve measuring from deck
surface:
» 36-1/8" (918 mm) for 36"
(914 mm) height.
» 42-1/8" (1070 mm) for 42"
(1067 mm) height.
3. Cutting Railings
See instructions on page 2.
POST
SLEEVES
WILL
NEED TO
BE CUT
Post sleeves WILL NEED TO BE CUT.
A. Pressure-treated post with Trex post sleeve
NOTE: » Only for use with 4" x 4" post sleeve.
» Trex post mounts or joist mount posts cannot be Enhance
cocktail design.
B. Deck board top rail.
NOTES: » Enhance and Escapes cannot be used
» Deck boards will need to be cut to fit each rail span
C. Enhance top rail
D
. Enhance bottom rail
E. Enhance balusters
36-1/8"
(918 mm)
or
42-1/8"
(1070 mm)
36-1/8"
(918 mm)
or
42-1/8"
(1070 mm)
2
IMPORTANT NOTE: SET DRILL TO LOW SPEED AND LOW CLUTCH SETTING
WHEN INSTALLING THESE SCREWS. DO NOT USE IMPACT DRIVER.