Instructions / Assembly

ManualsBrandsTrex ManualsBuilding SuppliesEnhance Railing Black Nylon Line Connector

Have Questions? NOTE: Construction methods are always improving. Please ensure you

1–800–BUY–TREX have the most up-to-date installation instructions by visiting: trex.com TESR-0720

Have Questions? NOTE: Construction methods are always improving. Please ensure you

1–800–BUY–TREX have the most up-to-date installation instructions by visiting: trex.com TESR-0720

TREX ENHANCE

STAIR RAILING

Installation Instructions

HOW TO INSTALL STANDARD STAIR RAILING/CONTINUED

TREX ENHANCE

Measuring and Cutting Top Stair Rail

9. Place two balusters into lower stair rail at each end closest to

the post.

10. Position top stair rail onto balusters, ensuring balusters are fully

seated in rail (position to side of post), and ENSURE balusters

are spaced evenly AND parallel with posts.

11. Mark top stair rail at post intersections.

12. Remove rail, and cut along the

marks.

NOTE: Verify the height of the

railing before installing rail to post

to ensure this meets proper height

requirements for stairs.

Attaching Brackets on Top Stair

Rail

13. Snap the top stair adaptor

bracket (labeled TOP) to the

standard bracket. Repeat for

remaining bracket.

TIP: Use a dap of super glue when snapping bracket together to

help stabilize bracket when installing.

14. On the TOP RAIL, attach the assembled stair brackets to the

side WITH the baluster holes. Attach both brackets using three

#8-18 x 1" self-drilling screws (provided).

Installing Balusters

15. Slide remaining balusters into

bottom rail until balusters are

fully seated.

Attachment of Top Rail

to Post

16. Place top rail onto balusters,

allowing the top rail to rest on

the surface of the balusters.

NOTE: For attachment of

brackets to posts, use at least a

3" long drill bit or extension so as

to not damage sides of rails when

installing.

TIP: Pre-drill prior to screw installation using a 7/64"

drill bit.

17a. Attach top stair rail bracket to upper post using two

#8-10 x 3" screws (provided).

17b. Attach top stair rail bracket to lower post using two

#8-10 x 3" screws (provided).

IMPORTANT NOTE: SET DRILL TO LOW SPEED AND LOW

CLUTCH SETTING WHEN INSTALLING THESE SCREWS. DO

NOT USE IMPACT DRIVER.

Attaching Post Caps and

Installing Foot Block

18. Secure post caps with

silicone or PVC adhesive.

Attach foot block per foot

block instructions.

NOTE: Clean up any excess

adhesive before it dries.

17b

17a