Installation Guide

140

TREX

SIGNATURE™ RAILING

NOTE: Construction methods are always improving. Please refer to www.trex.com for the most up-to-date installation requirements.

Measuring and Cutting Verticals

14. Clamp ﬁrst vertical (lower part of stairs) in place,

using width of stair template to position.

15. Clamp middle vertical(s) in place.

16. Slide a rod into top and bottom of all verticals.

Ensure that distance of top rod to top rail and

bottom rod to bottom rail are equal.

17. Clamp top vertical (upper part of stairs) in place,

using width of stair template to position.

18. Mark angle cuts at top and bottom on all verticals.

19. After removing rods

and verticals, make

angle cuts on top and

bottom of verticals

following marks from

previous step.

Vertical and Rod Assembly

20. Insert anti-rattle

strips into the vertical

supports.

NOTE:

There are two

anti-rattle strips for each

support which can only be

inserted in one side.

HOW TO INSTALL HORIZONTAL ROD RAILING STAIRS/CONTINUED

TREX

SIGNATURE™

STANDARD