Installation Guide

130
TREX
®
SIGNATURE RAILING
NOTE: Construction methods are always improving. Please refer to www.trex.com for the most up-to-date installation requirements.
HOW TO INSTALL FOOT BLOCKS – PANELS
TREX
®
SIGNATURE
Attachment of Foot Block (Required ONLY for All
Clear Span Applications Over 6
'
[1.83 m])
1. To ensure correct location, place foot block under
center of bottom rail. Mark to provide placement
location of base.
2. Place base (smaller
side facing down) on
decking surface. Attach
base of foot block
using one screw at an
angle through base and
into decking.
NOTE: Pre-drilling is recommended (1/8" [33 mm] drill
bit) for attachment of base.
3. After attaching, use a
rubber mallet along
with scrap piece of
wood to tap foot block
until it locks into place.
1
2
1
2
1
3