Installation Guide

120
TREX
®
SIGNATURE™ RAILING
IMPORTANT NOTE:
» Only for use with pressure-treated 4 x 4 post (3.5"
nominal square), Trex Post Mounts, or Joist Mount
Posts, and 4" x 4" (102 mm x 102 mm) or 6" x 6"
post sleeve. Trex
®
Signature™ Posts cannot be used
with Trex
®
Signature™ Traditional railing.
Installing Standard Trex
®
Signature™ Stair Posts, or
Pressure-treated Post
1. See instructions on page 106.
Installing Lower Stair Brackets
2. See instructions on page 107 for fixed stair brackets
or page 111 for swivel stair brackets.
How to Measure Bottom Stair Railings
3. See instructions on page 107 for fixed stair brackets
or page 111 for swivel stair brackets.
Cutting Bottom Stair Rail, Bottom Stair Rail Cover
4. See instructions on page 107 for fixed stair brackets
or page 111 for swivel stair brackets.
Attachment of Bottom Stair Rail Cover and Bottom
Stair Rail
5. See instructions on page 108 for fixed stair brackets
or page 112 for swivel stair brackets.
Installing Upper Stair Brackets and Measuring Upper
Rail
6. See instructions on pages 108 for fixed stair brackets
or page 112 for swivel stair brackets.
Cutting Top Stair Rail, Rail Insert and Cover
7. See instructions on page 109 for fixed stair brackets
or page 113 for swivel stair brackets.
Installing Balusters into Bottom Stair Rail
8. See instructions on page 109 for fixed stair
brackets or page 113 for swivel stair brackets.
Attaching Upper Stair Rails
9. See instructions on page 110 for fixed stair brackets
or page 113 for swivel stair brackets.
Attaching 2"x 4" to Top Rail
10. Place 2" x 4" (51 mm x 102 mm) beside top rail. Mark
and cut (both ends need to be cut on an angle for
proper fit).
HOW TO INSTALL TREX
®
SIGNATURE™ TRADITIONAL STAIR RAILING
TREX
®
SIGNATURE™
10
NOTE: Construction methods are always improving. Please refer to www.trex.com for the most up-to-date installation requirements.