Installation Guide

109

TREX

SIGNATURE™ RAILING

ATTACHING FIXED STAIR BRACKETS AND RAILS TO TREX

SIGNATURE™ POSTS AND PRESSURE-TREATED POST AND POST

SLEEVES/

CONTINUED

TREX

SIGNATURE™

Measuring Upper Stair Rail

11. On top stair post location, mark UNDERSIDE of

upper rail. On bottom stair post location mark

TOPSIDE of upper rail at angled intersection inside

the bracket.

Cutting Top Stair Rail Cover, and Attachment of Top

Stair Rail Cover

12. Cut each end of top stair rail along with rail insert

1/4" (0.6 cm) shorter than mark to allow for ﬁt into

top stair rail bracket.

NOTE: Railing does not need to be cut at angle.

Brackets are designed to allow for railing to be installed

with standard straight cut.

13. Mark and cut top rail

cover same length as

top rail for all top rail

conﬁgurations.

14. Attach “crowned" upper stair rail cover to upper

stair rail by aligning cover on one side of rail. Then

starting from one end of stair rail, snap cover onto

opposing slot working down length of stair rail.

GENTLE tapping with a rubber mallet may facilitate

fastening.

Installing Balusters into Bottom Stair Rail

15. Place balusters into holes

in lower stair rail by snap

ping fully into place. In

some cases, GENTLE

tapping with a rubber

mallet may facilitate

fastening.