Installation Guide

93
RAILING
93
TREX
®
SIGNATURE RAILING
Attach Upper Railings
13. Working from one end of upper rail, snap balusters
into upper rail working down length of rail. Fasten
center baluster into center slot using two #8 x 1-1/4"
(3.2 cm) screws (provided).
14. At post location, fasten
upper rail to each
bracket by installing
screws diagonally
through upper rail into
bracket using two self-
tapping screws each
side (provided).
NOTE: Pre-drilling is required (7/64" [0.28 cm] drill bit)
for attachment of railing to bracket.
15. At crossover post
location, fasten upper
rail to crossover post
by installing screws
diagonally through
upper rail into post using
two self-tapping screws
each side (provided).
NOTE: Pre-drilling is required (7/64" [0.28 cm] drill bit)
for attachment of railing to bracket.
16. Attach “crowned" upper rail cover to upper rail
by aligning cover on one side of rail. Then starting
from one end of rail, snap cover onto opposing slot
working down length of rail. In some cases, GENTLE
tapping with a rubber mallet may facilitate fastening.
Attachment of Bracket Covers, Skirts, and Caps
17. Attach corresponding bracket covers over opening
in upper and bottom rails.
18. Attach provided post skirt to bottom of posts when
using Trex® Signature™ posts.
19. Attach post caps to Trex® Signature™ posts.
(Use of rubber m a l l e t may be required for secure
attachment.)
20. Attach post caps to post sleeves using external
grade PVC construction adhesive.
2
14
1
7/64"
(.28 cm)
7/64"
(.28 cm)
1
1
13
2
1
16
3
2
2
15
1
7/64"
(.28 cm)
7/64"
(.28 cm)
1
19
Trex
Signature
post
®
2
Post
sleeve
20
3
1
18
Trex
Signature
post
®
2
1
2
1
17
HOW TO INSTALL HORIZONTAL RAILING POST TO CROSSOVER
POST/CONTINUED
TREX
®
SIGNATURE