Installation Guide

91
RAILING
91
TREX
®
SIGNATURE™ RAILING
2
1/4"
(0.6 cm)
1/4"
(0.6 cm)
1/4"
(0.6 cm)
1/4"
(0.6 cm)
KEY
Mark
Cut
KEY
Bottom rail
3
3/4 "
(1.9 cm)
3/4 "
(1.9 cm)
3/4 "
(1.9 cm)
3/4 "
(1.9 cm)
Bottom rail
1-1/2"
(3.8 cm)
1-1/2"
(3.8 cm)
4
Bottom rail
Bottom
rail cover
HOW TO INSTALL HORIZONTAL RAILING POST TO CROSSOVER
POST/CONTINUED
TREX
®
SIGNATURE™
Cutting Bottom Rail and Bottom Rail Cover ONLY
2. Cut each end of bottom rail 1/4" (0.6 cm) shorter
than mark on each end to allow for fit into bottom
rail brackets.
3. Slide rail insert out and cut 3/4" (1.9 cm) FROM
EACH SIDE of insert, then slide back inside rail
and center.
4. Mark and cut bottom
rail cover 1-1/2"
(3.8 cm) shorter than
bottom rail.
Cutting Top Rail
5. Top rail must be cut differently on each side of the
rail. Railing side that attaches to standard post should
be cut 1/4" (0.6 cm) shorter than the mark to allow
for fit into top rail bracket. Railing side that attaches
to the crossover post should be cut 3/4" (1.9 cm)
LONGER than the mark to allow for fit into the
crossover post bracket.
Cutting Top Rail Insert and Cover
6. Slide rail insert out and cut 3/4" (1.9 cm) FROM
EACH SIDE of insert, then slide back inside rail
and center.
7. Mark and cut top rail
cover same length as
top rail for all top rail
configurations.
7
5
KEY
Mark
Cut
KEY
Top rail
Standard post
Crossover post
3/4 "
(1.9 cm)
3/4 "
(1.9 cm)
1/4"
(0.6 cm)
1/4"
(0.6 cm)
6
3/4 "
(1.9 cm)
3/4 "
(1.9 cm)
3/4 "
(1.9 cm)
3/4 "
(1.9 cm)
Top rail
Lorem ipsum