Installation Guide

ManualsBrandsTrex ManualsBuilding SuppliesEnhance Railing Black Nylon Line Connector

TRANSCEND RAILING

HOW TO INSTALL CROWN AND UNIVERSAL BIRD'S MOUTH

RAILING/

CONTINUED

TREX TRANSCEND

HOW TO INSTALL CROWN AND UNIVERSAL STAIR RAILING

TREX TRANSCEND

Read all instructions BEFORE installation.

NOTE: All Transcend railings and gaskets ONLY work

with stair slopes of 32°-37°.

Installing Posts, Post

Sleeve Skirts, and Post

Sleeves for Stair Rails

1. Install posts, post

sleeve skirts, and post

sleeves according to

standard Transcend

railing instructions.

See page 65.

» In most cases, a post and post sleeve longer than

39" (991 mm) will be needed on the lower section of

stair rail to accommodate stair angle.

» Make sure top and bottom posts for stairs are

installed at nose of each tread.

Measuring and Cutting

Bottom Stair Rail

2. Place a 1" (254 mm)

deckboard on the nose

of the stair tread.

3. Snap baluster spacer into lower stair rail and lay

lower stair rail on top of the deckboard.

4. Use the lower and upper stair post to set the length

of the lower stair rail. Ensure that baluster spacer

holes are spaced evenly between posts. Also allow

for a minimum of 1-1/2" (292 mm) at each end of

the stair rail for bracket placement and baluster

clearance. Mark rail at post intersections.

5. Remove lower rail,

keeping baluster spacer

in rail, and cut along

marks.

NOTES:

» If using railing gaskets,

subtract 1/16” from

each end and cut.

» KEEP BALUSTER

SPACER IN RAILING

WHEN CUTTING.

CUT VERY CAREFULLY

TO NOT BREAK BALUSTER SPACER.

Attaching RSB’s for Bottom Stair Rail

6. Remove baluster spacer from bottom rail and place

rail in between posts, keeping rail on deckboard.

(2.5 cm)