Installation Guide

ManualsBrandsTrex ManualsDeck Railing SystemsEnhance 6 ft. x 36 in. Charcoal Black Composite Rail with Black Round Aluminum Baluster Kit-Horizontal

100

152

SELECT RAILING

NOTE: Construction methods are always improving. Please refer to www.trex.com for the most up-to-date installation requirements.

HOW TO INSTALL TREX SELECT STAIR RAILING/CONTINUED

TREX SELECT

Attachment of Bottom Rail to Post

6a. Assemble a few of the balusters into the bottom

and top railings (make sure balusters are setting at

90°) and set this on scrap material clearing the stair

treads to determine where bracket locations need

to be. Measure to make sure that the bottom railing

will clear the stair treads and the top railing will be

aligned with horizontal railing (remember in most

cases, a longer post and post sleeve will be needed

on the lower section of stair rail to accommodate

stair angle).

6b.

After locating

appropriate position

for bottom rail remove

top rail and balusters

and attach bottom rail

stair bracket to upper

post using two #8-10

x 3" wood screws

(provided).

6c. Attach bottom stair

rail stair bracket to

lower post using two

#8 10 x 3" wood

screws (provided).

For best results set

drill to low speed

when installing these

screws.

Install Balusters

7. Slide balusters into

bottom rail until

balusters are fully

seated.

Attachment of Top Rail to Post

8a. Place top rail onto

balusters, allowing the

top rail to rest on the

surface of the balusters.

8b. Attach top stair rail bracket to upper post using two

#8-10 x 3" screws (provided). For best results set

drill to low speed when installing these screws.

8c. Attach top stair rail bracket to lower post using two

#8-10 x 3" screws (provided). For best results set

drill to low speed when installing these screws.

Attaching Post Caps and Installing Foot Block

9. Secure post caps

with silicone or PVC

adhesive. Attach foot

block per foot block

instructions.

NOTE: Clean up any

excess adhesive before it

dries.