Installation Guide

151
SELECT RAILING
HOW TO INSTALL TREX SELECT STAIR RAILING/CONTINUED
TREX SELECT
Attaching Foot Block to Bottom Stair Rail
4. Invert the bottom stair
rail. Center and drill a
hole using a 3/16"
(5 mm) drill bit. This
will be location for foot
block (to be installed
last).
Attachment of Brackets to Railings
5a. Check fit for both
top and bottom
railings in designated
positions for location
onto posts. Remove
railings.
Upper Stair Post Locations
5b. Snap the top stair
adaptor bracket
(labeled TOP) to the
standard bracket.
Repeat for remaining
bracket.
5c. On the TOP RAIL, attach the assembled top stair
bracket to the side with baluster holes. On the
BOTTOM RAIL, attach the assembled top stair
bracket to the OPPOSITE SIDE of the baluster
holes. Attach both brackets using three #8-18 x 1"
self-drilling screws (provided).
Lower Stair Post Locations
5d. Snap the bottom
stair adaptor bracket
(labeled BOTTOM) to
the standard bracket.
Repeat for remaining
bracket.
5e. On the TOP RAIL, attach the assembled bottom
stair bracket to the side with baluster holes. On
the BOTTOM RAIL, attach the assembled bottom
stair bracket to the OPPOSITE SIDE of the baluster
holes. Attach both brackets using three #8-18 x 1"
self-drilling screws (provided).
4
5a
5d
1
1
5c
Top Rail Bottom RailBottom Rail
22
5b
1
1
5e
Top RailTop Rail Bottom RailBottom Rail
22