Installation Guide

Have Questions?
1–800–BUY–TREX
Note: Construction methods are always improving. Please ensure you
have the most up-to-date installation instructions by visiting:
trex. com TDL-1110
4
TREX
®
DECKLIGHTING™
How to Install
Installing Recessed Deck Lights
Note: Install recessed deck lights after installing decking.
1. Mark locations for lights in deck boards.
Note: If possible, avoid locations over joists as holes will be
more difficult to create.
2. Drill a 1" (2.5 cm) diameter hole 3/4" (1.9 cm) deep
into deck board. Hole cannot go all the way through
deckboard or light will fall through. Ensure drill bit is
perpendicular to board. Drill a 1/4" (0.6 cm) diameter
hole in base of the first hole through deck board.
3. Thread wires through hole. DO NOT pull LED into hole
by pulling on wires. This may damage wires or LED.
4. Press light into hole until
flush with surface. Make
connections under deck
with the provided wire nuts.
See Making Connections
on page 2.
1
3
4
1
2
2
3/4" (1.9 cm)