User Manual

TRex 61 / 113
high_cnt : 2
max_d_time : 1041 usec
sliding_average : 1 usec
v
2
precent : 100.0 %
histogram
-----------
h[1000] : 2
tempate_id_ 0 , errors: 0, jitter: 61
v
3
tempate_id_ 1 , errors: 0, jitter: 0
tempate_id_ 2 , errors: 0, jitter: 0
tempate_id_ 3 , errors: 0, jitter: 0
tempate_id_ 4 , errors: 0, jitter: 0
tempate_id_ 5 , errors: 0, jitter: 0
tempate_id_ 6 , errors: 0, jitter: 0
tempate_id_ 7 , errors: 0, jitter: 0
tempate_id_ 8 , errors: 0, jitter: 0
tempate_id_ 9 , errors: 0, jitter: 0
tempate_id_10 , errors: 0, jitter: 0
tempate_id_11 , errors: 0, jitter: 0
tempate_id_12 , errors: 0, jitter: 0
tempate_id_13 , errors: 0, jitter: 0
tempate_id_14 , errors: 0, jitter: 0
tempate_id_15 , errors: 0, jitter: 0
ager :
m_st_alloc : 1
m_st_free : 0
m_st_start : 2
m_st_stop : 1
m_st_handle : 0
v
1
Errors, if any, shown here
v
2
Low pass filter on the active average of latency events
v
3
Error per template info
Notes and Limitations:
• To receive the packets TRex does the following:
– Changes the TTL to 0xff and expects 0xFF (loopback) or oxFE (route). (Use --hop to configure this value.)
– Adds 24 bytes of metadata as ipv4/ipv6 option header.