User Manual

TRex 16 / 113
------------
link : link : Link Up - speed 10000 Mbps - full-duplex
promiscuous : 0
-Per port stats table
ports | 0 | 1 | 2 | 3
-------------------------------------------------------------------------------------
opackets | 1003 | 1003 | 1002 | 1002
obytes | 66213 | 66229 | 66132 | 66132
ipackets | 1003 | 1003 | 1002 | 1002
ibytes | 66225 | 66209 | 66132 | 66132
ierrors | 0 | 0 | 0 | 0
oerrors | 0 | 0 | 0 | 0
Tx Bw | 217.09 Kbps | 217.14 Kbps | 216.83 Kbps | 216.83 Kbps
-Global stats enabled
Cpu Utilization : 0.0 %
v
2
29.7 Gb/core
v
3
Platform_factor : 1.0
Total-Tx : 867.89 Kbps
v
4
Total-Rx : 867.86 Kbps
v
5
Total-PPS : 1.64 Kpps
Total-CPS : 0.50 cps
Expected-PPS : 2.00 pps
v
6
Expected-CPS : 1.00 cps
v
7
Expected-BPS : 1.36 Kbps
v
8
Active-flows : 0
v
9
Clients : 510 Socket-util : 0.0000 %
Open-flows : 1
v
10
Servers : 254 Socket : 1 Socket/Clients : ←-
0.0
drop-rate : 0.00 bps
v
11
current time : 5.3 sec
test duration : 94.7 sec
-Latency stats enabled
Cpu Utilization : 0.2 %
v
12
if| tx_ok , rx_ok , rx ,error, average , max , Jitter , max window
| , , check, , latency(usec),latency (usec) ,(usec) ,
-------------------------------------------------------------------------------------------------- ←-
0 | 1002, 1002, 0, 0, 51 , 69, 0 | 0 69 67
v
13
1 | 1002, 1002, 0, 0, 53 , 196, 0 | 0 196 53
2 | 1002, 1002, 0, 0, 54 , 71, 0 | 0 71 69
3 | 1002, 1002, 0, 0, 53 , 193, 0 | 0 193 52
v
1
Link must be up for TRex to work.
v
2
Average CPU utilization of transmitters threads. For best results it should be lower than 80%.
v
3
Gb/sec generated per core of DP. Higher is better.
v
4
Total Tx must be the same as Rx at the end of the run.
v
5
Total Rx must be the same as Tx at the end of the run.
v
6
Expected number of packets per second (calculated without latency packets).
v
7
Expected number of connections per second (calculated without latency packets).
v
8
Expected number of bits per second (calculated without latency packets).