Installation Guide

ManualsBrandsTrex Protect ManualsPaintTrex Protect 1-5/8 in. x 50 ft. Joist Tape Self-Adhesive Butyl Tape

INSTRUCTIONS

STEP 1

Clean the joist

surface making

sure it is dry and

free of any debris.

STEP 2

Cut the membrane

to the desired length

and remove tape

backing.

STEP 3

Apply tape to any

surface that can

hold water: all joists,

rim joists, beams

and ledger board.

TREX JOIST & BEAM TAPE INSTALLATION

PREPARATION

» Trex Protect Joist & Beam Tape

can be applied to horizontal

and vertical surfaces.

» Trex Protect Tape has two widths

making it convenient to apply to

double beams and joists. Use

1–5/8” (4.13 cm) Joist Tape for

joists and 3–1/8” (7.94 cm)

Beam Tape on all double beams.

» For best results, the Trex Protect

Tape should be installed when

temperatures are 50˚F (10˚C)

or greater.

If installing in cold weather or

when joists are wet, staple Trex

Protect to hold it in place while

attaching the deck boards.

The tape will seal when the

product warms above 40˚F

(4.5˚C).

» When pulling deck boards onto the

deck, a piece of plywood or wafer

board can be used to overhang the

edge of the deck. This will prevent

the product from rolling up and

pulling up from the joist.

JOIST & BEAM TAPE

For more information, visit trexprotect.com or call 1-877-348-1385

Protect

™

is manufactured and/or distributed by Dri-Deck Enterprises,

LLC. Trex

is a trademark of, and is used by Dri-Deck Enterprises, LLC. under a license with, Trex Company, Inc.

NOTE:

Trex Protect cannot be used when installing Trex RainEscape.