Installation Guide
Fence Distributors
23
tep 5: Mount the Drop Rod
A. -
Reverse the drop rod brackets depending on which side of the gate the drop
rod is to be mounted.
B. 3” from the
2” self-drilling screws on the inside edge
of the gate panel upright and (1) 1” self-drilling screw on the face of the
14” from
C.
24”
el and 2” to the center of the
screw holes from the edge of the
gate panel.
D.
where the drop hits. If the gate is
over a concrete pad drill an 8”
deep hole using a 3/4” masonry
bit for the drop rod to slide into
when the gate is closed. For gates
over so dig a hole 8” wide x 18”
deep below the rod ll it with
concre and insert an 8” long
3/4” pvc pipe in the concrete for
the concrete has cured.
TM