Installation Guide

Fence Distributors

11/16” wrench.

Note: Due to weather and temperature changes periodic hinge adjustment may be necessary to



A. -

only one panel is in use) approximately 36” from the ground (or to desired height)

using the supplied 1 1/2” self-drilling screws. The latch should be oriented so the

catch is on the gate-swing side of the post. The catch will face up or down depend-

B. Using the supplied 1 1/2” self-

the gate pane lining the striker rod

up with the catch on the post latch.

panel upright using the supplied 1”

self-drilling screws. Handles should

3/4” in from the edge

of the gate panel. The handle height must







