Installation Guide

Mark the aluminum   rail  and top for
length by holding them next to the post.* (see ig. )
Cut the aluminum rail with a nonferrous metal  blade.
Cut the aluminum 1/2” shorter (do not cut the rail covers
shorter) to avoid scratching the post during  If the dis-
tance between posts is 91”
the aluminum rail will not need to be cut.
Cut top rail and rail covers with miter saw
Slide the rail covers over the aluminum rail as shown
(see Fig. 8). Place the  rail over the 
with the deeper channel facing down.
Fig.
deeper channel
rackets
Fig.
10
5.
Set the top rail in place over the brackets. Leave the rail in place while

4.
Fence Distributors
