Installation Guide
Fence Distributors
20
tep 1: Set the ate Posts
A.
B. Set posts into post holes**. The holes should be 30”deep by 12”
wide***. Plumb and level posts so they are parallel with each
other and ll hole with concrete mix .
C. The opening (measuring from the inside face of one post to in-
side face of the other post) for 2 standard size Trex Horizons
te panels should be 91 1/2” wide. (****The opening for a dou-
ble gate using Large Trete panels is 130 1/2” wide) Custom
heights and widths are possible.
**Note: Due to concrete cure
-3
days before gate is installed.
*Note: If the Hinge Post is not
connected to a fence panel or if
a large gate panel is used it may
be necessary to use a Heavy
***Note:
and codes for actual depth.
**
TM