Installation Guide
Fence Distributors
16
tep 1: Set the ate Posts
A.
faces away from the gate opening.
B. Set posts** into post holes. The holes should be 30” deep
by 12” wide***. Plumb and level posts so they are parallel
with each other and ll the hole with concrete mix.
C. The opening (measuring from the inside face of one post
to inside face of the other post) for a standard size Trex
Horizonste panel should be 46 1/4”. (****The opening
for a standard Large Size Trex ate panel is 65 3/4” wide)
Custom heights and widths are possible.
**Note: Due to concrete cure
-3
days before gate is installed.
*Note: If the Hinge Post is not
connected to a fence panel or
if a large gate panel is used it
may be necessary to use a
***Note:
and codes for actual depth.
**
TM