Installation Guide

2
Step 5: Mount the Drop Rod
A. -
Reverse the drop rod brackets depending on which side of the gate the drop
rod is to be mounted.
B. 3” from the
2” self-drilling screws on the inside edge of
the gate panel upright and 1” self-drilling screw on the face of the gate pan-
14” from the
C.
24”
el and 2” to the center of the
screw holes from the edge of the
gate panel.
D.
where the drop rod hits. If the
gate is over a concrete pad drill
an 8” deep hole using a 3/4” ma-
sonry bit for the drop rod to slide
into when the gate is closed. For
gates over so dig a hole 8” wide
x 18” deep below the rod ll it
with concre and insert an 8”
long 3/4” PVC pipe in the con-
crete for the drop rod to slide
23
Fence Distributors
