User guide

DME 3228DME 3228

DME 3228 METEO STATION

P_14P_14

P_14

Hold “CLOCK “ button to enter clock setting mode. Using “ ”or “ “ to adjust and “CLOCK” to confirm, the following values can be set

in sequence: 12/24hr format > Hr > Min > Yr > D/M or M/D format > Month > Date > EXIT

HOME TIME, WORLD (ZONE) TIME

Hold “ZONE” to enter world (zone) time setting mode. Press “ “or “ “ to enter the desired hour offset value from –12 to +12 hours.

Press “ZONE” to confirm each setting.

Press “ZONE“ button to toggle between home time and world (zone) time. “ZONE” icon appears when world (zone) time is selected.

When zone time is not used, set zone time to “0”.

ALARM SETTING

Press “ALARM” to show alarm time and “AL.” icon will appear. Press again to enable or disable the alarm. Bell icon “ ” appears when

alarm is enabled.

Hold “ALARM” to enter alarm time setting mode. Press “

”or “ ” to enter the desired Hr/Min values and press “ALARM“ to confirm

setting.

SNOOZE & BACKLIGHT

When alarm is going off, press SNOOZE/ LIGHT to trigger snooze alarm and “Zz” icon will appear. To stop alarm for one day, press

“ALARM” key. Press SNOOZE/LIGHT for an extended backlight if adapter is not connected.

DISPLAY BRIGHTNESS CONTROL

Select display brightness mode with the slide switch on the back casing.

- AUTO:

Display brightness is adjusted automatically according to the surrounding brightness detected by the light sensor located on the left

of the Snooze/Light button. In a bright environment, display brightness will increase. As the environment turns dark, display

brightness will reduce.

(Note: Auto mode is recommended for power saving, display lifetime and convenient purpose)

(Important: Avoid having obstacle above the light sensor window for an accurate light sensing result. Otherwise the display will turn

dim even in bright environment)

ENGLISHENGLISH

ENGLISH