Owner's Manual

Pae 12
Step 8
å
Separate the EXTENSION SLIDES (4) from the EXTENSION RAILS (3)
as shown in the upper diaram below. Be prepared, the parts are reasy.
å
Fasten the EXTENSION RAILS (3) to the EXTENSION BLOCKS (R) on
the RIGHT END (H) and UPRIGHT (F). Use four BLACK 1/2" FLAT HEAD
SCREWS (23).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in
the enlared diaram. Then, slide the inner cartride of the EXTENSION
RAIL in to fi nd the other hole that lines up with the hole in the END and
UPRIGHT. Turn a SCREW into this hole.
å
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
Open end
Push the black lever up and pull the SLIDE from the RAIL.
Open end
3
3
3
4
Use these holes
to fasten the
EXTENSION RAIL.
H
F
R
R
BLACK 1/2" FLAT HEAD SCREW
(4 used in this step)
23