Owner Manual
Step 8
å
Separate the EXTENSION SLIDES (4) from the EXTENSION RAILS (3) as shown in the upper
diaram below. Be prepared, the parts are reasy.
å
Fasten the EXTENSION RAILS (3) to the EXTENSION BLOCKS (R) on the RIGHT END (H)
and UPRIGHT (F). Use four BLACK 1/2" FLAT HEAD SCREWS (23).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlared
diaram. Then, slide the inner cartride of the EXTENSION RAIL in to fi nd the other hole that
lines up with the hole in the END and UPRIGHT. Turn a SCREW into this hole.
å
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
Open end
Open end
3
3H
F
R
R
BLACK 1/2" FLAT HEAD SCREW
(4 used in this step)
23
Push up on the black lever and
pull the SLIDE from the RAIL.
4
3
Use these holes to fasten
the EXTENSION RAIL.
Pae 12