ASSEMBLY INSTRUCTION METAL QUEEN BED A Headboard Leg Headboard Foot board Rail Section PCS 1PC 1PC PCS Rail Section Front / Rear Support Center Support Bar Front Center Rail Bar ~~ 7 PCS PCS 1PC 1PC 1 Rear Center Rail Rail Support Legs K Center Support Legs Slat 1PC PCS PCS PCS Slat Connector Bolt Bolt Bolt > PCS PCS PCS PCS Nut L-Allen Key Wrench 1/4" 4mm 5/16" 1/4" PCS 1PC 1PC This page lists all the contents included in the box.
( Attach the Headboard Leg (A) to the Headboard (B), insert the Bolt (N), turn the L-Allen Key (R) to tighten them. ps Attach the Rail Section (D), Rail Section (E) and Rail Support Leg (J), insert the Bolt (N), turn the L-Allen Key (R) to tighten them. 0 Attach the Center Support Bar (G) to rails, and then insert the Bolt (O) and Nut (Q), turn the L-Allen Key (R) and Wrench (S) to tighten them.
4 Attach the Front / Rear Support Bar (F) to rails, insert the Bolt (O), turn the L-Allen Key (R) to tighten them. 3 Attach the Front Center Rail (H) and Rear Center Rail (I) to the Front / 9S Rear Support Bar (F) and Center Support Bar (G), insert the Bolt (N), turn the L-Allen Key (R) to tighten them. Insert the Bolt (P) and Nut (Q), turn the L-Allen Key (R) and Wrench (S) to tighten them. Attach the Center Support Leg (K) to the center rails, insert the Bolt (N), turn the L-Allen Key (R) to tighten them.
7 Attach the assembled metal frame to the Headboard Leg (A), Headboard (B) and Foot board (C), insert the Bolt (N), turn the L-Allen Key (R) to tighten them. Insert the Slat Connector (M) to the both sides of Slat (L), press the Slat (L) into the correct place. Attached the Slat (L) to rails, put the Slat Connectors (M) into the correct place and press them down. Cleaning & Care Treat surface with care. Surface is resistant to scratches but is not scratch resistant.
