Assembly And Installation Instructions

1. Attach the nipple to the mounting strap, then secure it
with a washer and hex nut.
2. Attach the mounting strap to the outlet box by using
two mounting screws.
3. Secure the top loop to the nipple.
4. Take a glass panel and gently slide the narrow side
of the glass panel down into the metal frame in
place, secure it by pressing the clips from both top
and bottom sides. (See Fig.1 & Fig.2) Repeat with
other panels.
5. Choose the length of the chain you need, then weave
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT
BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
Outlet Box
House Grounding Wire
Wire Nut (F)
Fixture Wire
Fixture Grounding Wire
Mounting Strap (A)
Green Grounding Screw (C)
Mounting Screw (B)
Nipple (G)
Canopy (H)
Top Loop (J)
Hex Nut (D)
Washer (E)
Collar (I)
Loop Lock (K)
Loop Lock
Chain (L)
Loop
Glass Panel (M)
Metal Frame
Parts:
Bulb Type ST Max.40W
(not included)
Glass Panel
Fig.1
Clip
Glass Panel (M) (X4)
Mounting Strap (A)
Mounting Screw (B)
Green Grounding
Screw (C)
Hex Nut (D)
Wire Nut (F)
Nipple (G)
Canopy (H)
Collar (I)
Washer (E)
Top Loop (J)
Loop Lock (K)
Chain (L)
Fig.2
Clip
the fixture wire and the fixture grounding wire through
the chain, collar and canopy.
6. Connect one end of the chain with the loop by using a loop lock.
7. Connect the other end of the chain with the top loop by using
another loop lock.
8. Thread the fixture wire and fixture grounding wire through the top
loop, nipple and mounting strap.
9. Pull out the outlet wires and house grounding wire from the outlet
box. Make wire connections using the wire nuts:
---The smooth wire (marked) from the fixture to the black wire from the power source.
---The ridged wire (unmarked) from the fixture to the white wire from the power source.
---Attach the fixture grounding wire to the mounting strap with the green grounding screw. Then
connect it to the house grounding wire with a wire nut.
Carefully put the wires back into the outlet box.