1. Insert 2 dowels (#F) into each end of the leg support (#3), and the other ends of the dowels into the right and left H/board legs (#2). 2. Prepare 2 bolt assemblies by applying a lock washer (#C) onto the bolt (#B) then a flat washer (#D) onto that same bolt (#B). Insert a bolt assembly into each end of the leg support (#3) and secure using the Allen wrench (#E).
1. Carefully place the headboard (#1) onto the top of the H/board legs (#2). 2. Prepare 6 bolt assemblies by applying a lock washer (#C) onto the bolt (#A) then a flat washer (#D) onto that same bolt (#A). Insert 3 bolt assemblies into each end of the headboard (#1) and secure using the Allen wrench (#E). 6 6 6 1. Insert 2 threaded studs (#G) into the holes along the sides of the headboard (#1) and footboard (#4). Turn right to tighten. 2.
Insert the threaded ends of the slat supports (#8) into the holes along the slat center (#7). Turn right to tighten. 1. Apply the slats (#6) onto the side rails (#5). 2. Turn the slat support legs (#8) along the center to the right. This will connect the slat center (#7) to the slats (#6). 3. Insert a screw (#K) into the ends of the slats (#6). Secure using the Phillips screwdriver.
