Installation & Assembly

(3)MediumBaseDecorativeFilament60Wbulb(provided),Maximum100W,Alternatebulb(3)23WCFLMaximum.
30-45minutes
Identifyandinspectallpartsbeforebeginninginstallation.Checkpackagecontentlistanddiagramsbelowtobesureallpartsare
present.Ifanypartsaremissingordamaged,donotattempttoassemble,install,oroperatethefixture.Contactcustomerserviceforreplacement
parts.
Warnings and Cautions
1of2
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal. Do not subject
glass parts to any shock while in operation or shattering may result.
C
Fixture
Body
x1
Package Contents
E
B
Lock
Screw
x2
Inner Backplate
x1
STEP 1 Install Inner Backplate and Fixture Body-
A. Pass the supply wires through Inner Backplate (A). Attach Inner
Backplate (A) to Outlet Box with the head of Green Ground Screw
facing you. Secure it with Outlet Box Screws (not included). Tighten
until snug
B. Race all supply wires through the Inner Backplate (A) as shown.
Refer to Step 2 for wiring connections.
C. Attach Fixture Body (C) over Inner Backplate (A) and secure with
Lock Screws (B). Tighten until snug with screwdrivers.
.
A
Shade
x3
A
White wire
from supply
White wire
from fixture
Black wire from
supply (or Red)
Black wire
from fixture
Ground wire
from supply
Ground wire
from fixture
Figure 2
Figure 1
Outlet Box
C
B
STEP 3 - Install Shades, Bulbs and
Bulb Shields
A. Place Shade (E) over the Cup, line
up the mounting hole on the Cup
and the hole on the Shade (E),
secure by threading the Lock
Screw (F) onto the mounting hole.
Hand tighten until sung.
B. This fixture uses Medium Base
Decorative Filament 60W bulb
(D), Maximum 100W. Insert bulb
and screw snugly into place.
Your fixture is now assembled and
ready to use. Enjoy!
Cup
Figure 3
STEP 2 - Wire Connections
A. Use standard wire connectors (not included) to make all wire
connections. (Connectors are not included with fixture.) Twist
connectors until wires are tightly joined together. Wrap each
connection with approved electrical tape and carefully stuff all the
connected wires between Inner Backplate (A) and Fixture Body (C).
D
Edison Bulb
x3
F
Lock
Screw
x9
C
E
F
D
Assembly Instruction Sheet
LightSource:
EstimatedAssembly Time:
Preparation:
ToolsRequired:Flatheadscrewdriver,Phillipsscrewdriver,pliers,wirecutters,wirestrippers,electricaltape,safetyglasses
.