Quick Installation Guide TV-M7 H/W: A1
Table of Contents Table of Contents English .................................................................................................................. 1. Before You Start ............................................................................................ 2. Hardware Installation ..................................................................................... 3. Configure the Wireless Settings .................................................................... 4. Add IP Camera ........
1. Before You Start Package Contents TV-M7 ? User Guide CD-ROM ? Quick Installation Guide ? ? AC Power Adapter (12V, 1.
2. Hardware Installation 1. Connect the AC Power Adapter to the Digital Photo Frame and then to a power outlet. 2. Turn the Power Switch to the On position on top of the TV-M7. 3. Verify that the Pwr LED is green.
3. Configure Wireless Settings 1. The main menu will appear after you turn on the TV-M7. If the main menu does not appear, press Home on the remote control. Then press Setup. 2. Select Networking Setup using the down arrow on the remote control. Then press Enter. 3. Select SSID (Wireless Network Name) and then press Enter. 4. Select AUTO SCAN and then press Enter.
5. Select the SSID for your wireless Network and then press Enter. 6. Press ESC. 7. Select Authentication Mode to select the encryption type (e.g. WEP, WPA-PSK, WPA2-PSK). 8. Select Key (WEP) or Pre-Shared Key (WPA-PSK/WPA2-PSK) to enter your encryption key.
9. Select Apply Settings using the down arrow on the remote control. Then press Enter. 10. Press ESC to exit out of Setup. 11. Verify that the LINK LED is blinking green.
4. Add IP Camera Note: 1. The TV-M7 supports the following IP Cameras: TV-IP110, TV-IP110W, TV -IP212, TV-IP212W, TV-IP312, TV-IP312W, TV-IP410, TV-IP410W, TV-IP422 and TV-IP422W. All other IP cameras are not supported. 2. Make sure both the TV-M7 and your IP cameras(s) have IP address in the same subnet. For example, if TV-M7 has an IP Address of 192.168.10.80, then your IP camera must use 192.168.10.X. 1. The main menu will appear after you turn on the TV-M7.
5. Remote Control Function Button Function HOME SETUP SNAPSHOT Enter Main Menu screen Enter Setup screen Take snapshot in IP CAM view. Snapshots are saved in internal memory.
Button Function DOWN ARROW ENTER ROTATE / REFRESH Navigate Down Execute Selection Rotate Image in Photo mode Refresh screen 5x Zoom on Image Select camera or cameras in IP Cameras menu Turn Volume Up Turn Volume Down Turn Off Audio Display IP camera(s) Play/Pause Slideshow and Video Set up time and date Rewind Video Stop Video Fast Forward Video ZOOM / SELECT VOLUME UP VOLUME DOWN MUTE IP CAM PLAY/PAUSE CALENDAR REWIND STOP FAST FORWARD Your installation is now complete.
Troubleshooting Q1: The Digital Picture Frame doesn't power on. What should I do? A1: First, make sure that you connect the power adapter securely to the Digital Frame and to a working power outlet. Second, make sure to set the power switch to the On position. Please note: there is no power button on the remote control. Q2: After I successfully configured the TV-M7 to match my wireless network settings, I can not connect or view my IP cameras.
Certifications This equipment has been tested and found to comply with FCC and CE Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received. Including interference that may cause undesired operation. Waste electrical and electronic products must not be disposed of with household waste. Please recycle where facilities exist. Check with you Local Authority or Retailer for recycling advice.
Product Warranty Registration Please take a moment to register your product online. Go to TRENDnet’s website at http://www.trendnet.com/register 20675 Manhattan Place Torrance, CA 90501 USA Copyright ©2008. All Rights Reserved. TRENDnet.
