Quick Installation Guide TEW-691GR 1.
Table of Contents English 1. Before You Start 2. Hardware Installation 3. Configure the wireless router 1 1 2 3 Troubleshooting 5 Version 05.11.
1. Before You Start Package Contents TEW-691GR ? ? Multi-Language Quick Installation Guide ? CD-ROM (User’s Guide) ? Cat. 5 Ethernet cable (1.5m / 4.9ft) ? Power Adapter (12V DC, 1A) System Requirements A computer with a wired or wireless network adapter properly installed. ? ? Web Browser: Internet Explorer (6.
2. Hardware Installation Note: Gather all information related to your Internet Connection before you start. If necessary, contact your Internet Service Provider (ISP). 1. Verify that you have an Internet connection when connecting your computer directly to the Cable or DSL modem or Ethernet jack. For example, open your browser (e.g. Internet Explorer) and type in a URL (e.g. http://www.trendnet.com) in the address bar. 2.
3. Configure the wireless router Note: It is recommended that you configure the Wireless Router from a wired computer. 1. Open your web browser, type http://192.168.10.1 in the Address bar, and then press Enter. 2. Enter the User Name and Password, and then click OK. User name: admin By default, there is no password. Note: User name is case sensitive. 3. Click Network and then click WAN Setting. Then select the proper Internet Connection Type. 4.
Note: The example below is for WPA2-PSK security. If you select WPA-PSK or WPA2-PSK, make sure your wireless adapters support WPA2 or WPA. If your wireless adapters do not support WPA or WPA2, then select WEP. 6. Select the desired WPA mode, enter characters for your Pre-Shared key and then click Apply. For WPA-PSK or WPA2-PSK, the Pre-Shared Key must be between 8 and 63 ASCII or 64 HEX characters. Make sure to copy down the Pre-Shared Key.
Troubleshooting 1. I typed http://192.168.10.1 in my Internet Browser's Address Bar, but an error message says “The page cannot be displayed.” How can I get into the TEW-691GR's web configuration page? 1. Check your hardware settings again by following the instructions in Section 2. 2. Make sure the LAN and WLAN lights are lit. 3. Make sure your TCP/IP settings are set to Obtain an IP address automatically (see the steps below). 4. Press on the factory reset button for 15 seconds. Windows 7 1.
Windows XP/2000 1. Go into the Control Panel, double-click the Network Connections icon and then right-click the Local Area Connection icon and then click Properties. 2. Click Internet Protocol (TCP/IP) and then click Properties. Then click on Obtain an IP address automatically. 2. I am not sure what type of Internet Account Type I have for my Cable/DSL connection. How do I find out? Contact your Internet Service Provider's (ISP) support service for the correct information. 3.
Copyright ©2010. All Rights Reserved. TRENDnet.
