Quick Installation Guide TL2-PG484(V1)
Table of Content 1 English 1. Before You Start 2. Quick Reference 3.
1. Before You Start Package Contents Ÿ TL2-PG484 Ÿ Quick Installation Guide Ÿ CD-ROM (Utility and User's Guide) Ÿ Power cord Ÿ Rack mount kit Minimum Requirements Ÿ Computer with an Ethernet port and web browser Ÿ Network cable Optional Equipment Ÿ EIA standard 19” rack Ÿ SFP modules (e.g. TEG-MGBSX, TEG-MGBS10, TEG-MGBS40, TEG-MGBS80, TEG-MGBS10D3, TEG-MGBS10D5, TEG-MGBS40D3, TEG-MGBS40D5) 2. Quick Reference Network 802.3af PoE TL2-PG484 RX TX 802.
3. Hardware Installation and Configuration 1 2 3. Assign a Static IP address to your computer's network adapter in the subnet of 192.168.10.x (e.g. 192.168.10.25) and a subnet mask of 255.255.255.0. 4. Open your web browser, type the IP address of the switch in the address bar, and then press Enter. The default IP address is 192.168.10.200.
. Enter the User name and Password, and then click LOGIN. By default: User Name: admin Password: admin Note: User Name and Password are case sensitive. 6. Click System and then click IPv4 Setup. 7. Configure the switch to match the requirements of your network. Then click Apply. 8. Click OK.
9. Click Save Settings to Flash (menubar). 10. Click Save Settings to Flash (button). 11. Click OK. OK Note: If you would like to easily discover all the Web Management Switches on the network, assign IP Address, change the password, and upgrade new firmware, then install the TRENDnet Switch Management Utility. For detailed information regarding the TL2-PG484’s configuration and advanced settings, please refer to the User's Guide on the provided CD-ROM.
Manufacturer’s Name and Address TRENDnet, Inc. 20675 Manhattan Place Torrance, CA 90501 USA Product Information: TL2-PG484 Model Number: 48-Port Gigabit PoE+ Managed Layer 2 Switch with 4 shared SFP slots Product Name: TRENDnet Trade Name: TRENDnet hereby declare that the product is in compliance with the essential requirements and other relevant provisions under our sole responsibility.
Informations générales GPL/LGPL Ce produit TRENDnet comprend un logiciel libre gratuit par des programmeurs tiers. Ces codes sont sujet à la GNU General Public License ("GPL" Licence publique générale GNU) ou à la GNU Lesser General Public License ("LGPL" Licence publique générale limitée GNU). Ces codes sont distribués SANS GARANTIE et sont sujets aux droits d'auteurs des programmeurs. TRENDnet ne fournit pas d'assistance technique pour ces codes.
Limited Warranty TRENDnet warrants its products against defects in material and workmanship, under normal use and service. Specific warranty periods are listed on each of the respective product pages on the TRENDnet website. Garantie Limitée TRENDnet garantit ses produits contre les problèmes de matériel ou de fabrication, dans des conditions normales d'utilisation et de service. Les périodes de garanties précises sont mentionnées sur chacun des pages produits du site web de TRENDnet.
Safety notes Before using your TRENDnet device for the first time, it is essential to read and understand all safety and operating instructions. Keep instructions in a safe place for future reference. Some TRENDnet products are rated for outdoor applications and can sustain certain weather conditions. Please refer to the product's Ingress Protection (IP) rating and the operating humanity and temperature range. DANGER due to electricity Warning: Never open TRENDnet devices.
Certifications This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received. Including interference that may cause undesired operation. Waste electrical an electronic products must not be disposed of with household waste. Please recycle where facilities exist. Check with your Local Authority or Retailer for recycling advice.
