User Guide

© Copyright 2019 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
Industrial Managed Switch Series
117
CLI Configuration
Node
Command
Description
enable
show auto-provision
This command displays the current auto
provision configurations.
configure
auto-provision
This command enters the auto-provision node.
auto-
provision
show
This command displays the current auto
provision configurations.
auto-
provision
active
(enable|disable)
This command enables/disables the auto
provision function.
auto-
provision
server-address
IPADDR
This command configures the auto provision
server’s IP.
auto-
provision
protocol
(tftp|http|ftp)
The command configurations the upgrade
protocol.
auto-
provision
FTP-user username
STRING password
STRING
The command configurations the username
and password for the FTP server.
auto-
provision
folder STRING
The command configurations the folder for the
auto provision server.
auto-
provision
no folder
The command configurations the folder to
default.
auto-
provision
no FTP-user
The command configurations the username
and password to default.
Web Configuration
Management > Auto Provision
Mail Alarm
The feature sends an e-mail trap to a predefined administrator when some events
occur. The events are listed below:
 System Reboot : The system warn start or cold start.
 Port Link Change : A port link up or down.
 Configuration Change : The system configurations in the NV-RAM
have been updated.
 Firmware Upgrade : The system firmware image has been
updated.
 User Login : A user login the system.
 Port Blocked : A port is blocked by looping detection or
BPDU guard.
Default Settings
Mail-Alarm Configuration:
-----------------------------------------------
State : Disabled.
Server IP : 0.0.0.0
Server Port : 25