User's Guide

© Copyright 2018 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
Managed Industrial L2 Switch
96
Cost range:
16-bit based value range 1-65535,
32-bit based value range 1-
200000000.
interface
no spanning-tree cost
This command configures the path
cost to default for the specific port.
interface
spanning-tree port-priority <0-
240>
This command configures the port
priority for the specific port.
Default: 128.
interface
no spanning-tree port-priority
This command configures the port
priority to default for the specific
port.
configure
interface range
gigabitethernet1/0/PORTLISTS
This command enters the interface
configure node.
if-range
spanning-tree (disable|enable)
This command configures
enables/disables the STP function
for the specific port.
if-range
spanning-tree bpdufilter
(disable|enable)
This command configures
enables/disables the bpdufilter
function for the specific port.
if-range
spanning-tree bpduguard
(disable|enable)
This command configures
enables/disables the bpduguard
function for the specific port.
if-range
spanning-tree rootguard
(disable|enable)
This command enables/disables the
BPDU Root guard port setting for
the specific port.
if-range
spanning-tree edge-port
(disable|enable)
This command enables/disables the
edge port setting for the specific
port.
if-range
spanning-tree cost VALUE
This command configures the cost
for the specific port.
Cost range:
16-bit based value range 1-65535,
32-bit based value range 1-
200000000.
if-range
no spanning-tree cost
This command configures the path
cost to default for the specific port.
if-range
spanning-tree port-priority <0-
240>
This command configures the port
priority for the specific port.
Default: 128.
if-range
no spanning-tree port-priority
This command configures the port
priority to default for the specific
port.
Web Configuration
Advanced Settings > STP > General Settings
Parameter
Description
State
Select Enabled to use Spanning Tree Protocol (STP) or Rapid
Spanning Tree Protocol (RSTP).