User's Guide

© Copyright 2018 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
Managed Industrial L2 Switch
78
interface
no lacp port_priority
This command configures the
default for the priority for the
specific port.
configure
interface range
gigabitethernet1/0/PORTLISTS
This command enters the interface
configure node.
if-range
lacp port_priority <1-65535>
This command configures the
priority for the specific ports.
Note: The default value is 32768.
if-range
no lacp port_priority
This command configures the
default for the priority for the
specific ports.
Web Configuration
LACP Settings
Advanced Settings > Link Aggregation > LACP
Parameter
Description
State
Select Enable from the drop down box to enable Link
Aggregation Control Protocol (LACP).
Select Disable to not use LACP.