User's Guide

© Copyright 2018 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
Managed Industrial L2 Switch
41
configure
interface range
gigabitethernet1/0/ PORTLISTS
This command enters the interface
configure node.
if-range
description STRINGs
This command configures a
description for the specific ports.
if-range
no description
This command configures the
default port description for the
specific ports.
if-range
shutdown
This command disables the specific
ports.
if-range
no shutdown
This command enables the specific
ports.
if-range
speed (auto|10-full||10-half|
100-full|100-half|1000-full)
This command configures the
speed and duplex for the port.
Example:
[DEVICE_NAME]#configure terminal
[DEVICE_NAME](config)#interface gi1/0/1
[DEVICE_NAME](config-if)#speed auto
Web Configuration
Basic Settings > Port Settings > General Settings
Parameter
Description
Port
Select a port or a range ports you want to configure on this screen.
State
Select Enable to activate the port or Disable to deactivate the port.
Speed/Duplex
Select the speed and duplex mode of the port. The choices are:
• Auto
• 10 Mbps / Full Duplex
• 10 Mbps / Half Duplex
• 100 Mbps / Full Duplex
• 100 Mbps / Half Duplex
• 1000 Mbps / Full Duplex
Flow Control
Select On to enable access to buffering resources for the port thus
ensuring lossless operation across network switches. Otherwise,
select Off to disable it.
Apply
Click Apply to take effect the settings.
Refresh
Click Refresh to begin configuring this screen afresh.
Port
This field displays the port number.
State
This field displays whether the port is enabled or disabled.
Speed/Duplex
This field displays the speed either 10M, 100M or 1000M and the
duplex mode Full or Half.
Flow Control
This field displays whether the port’s flow control is On or Off.
Link Status
This field displays the link status of the port. If the port is up, it
displays the port’s speed, duplex and flow control setting.
Otherwise, it displays Link Down if the port is disabled or not
connected to any device.