User's Guide

© Copyright 2018 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
Managed Industrial L2 Switch
160
TI-G160i
Standards
• IEEE 802.1d
• IEEE 802.1p
• IEEE 802.1Q
• IEEE 802.1w
• IEEE 802.1X
• IEEE 802.1ab
• IEEE 802.1ax
• IEEE 802.3u
• IEEE 802.3x
• IEEE 802.3ab
• IEEE 802.3ad
• IEEE 802.3az
Device Interface
• 16 x Gigabit ports
• 6-pin removable terminal block (primary/RPS power inputs & alarm relay
output)
• DIP switch (Alarm for Primary/RPS power)
• LED indicators
• Reboot button
Data Transfer Rate
• Ethernet: 10 Mbps (half-duplex), 20 Mbps (full-duplex)
• Fast Ethernet: 100Mbps (half duplex), 200Mbps (full duplex)
• Gigabit Ethernet: 2000Mbps (full duplex)
Performance
• Switch fabric: 32Gbps
• RAM buffer: 128MB
• MAC address table: 8K entries
• Jumbo frames: 10KB
• Forwarding mode: store and forward
• Forwarding rate: 23.8Mpps (64-byte packet size)
Management
• HTTP web based GUI
• CLI: Telnet / SSHv2
• SNMP v1, v2c, v3
• SNMP trap (up to 5 receivers)
• RMON groups 1/2/3/9
• Device configuration backup & restore, upgrade firmware, reboot, and reset to
default
• Multiple administrative or read-only user accounts
• Enable or disable power saving mode per port
• Static unicast entries
• LLDP (Link layer discovery protocol)
• Netlite device map
• ONVIF device discovery
• SNTP
• SMTP alert
• Syslog
• Port statistics/utilization
• Traffic monitor
• Port mirror: one to one, many to one
• Storm control: Broadcast, multicast, destination lookup failure (Min. limit:
1pps)
• Loopback detection
• DHCP relay/option 82
MIB
• MIB II RFC 1213
• Bridge MIB RFC 1493
• RMON (Group 1,2,3,9) RFC 1757