User's Guide

© Copyright 2018 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
Managed Industrial L2 Switch
139
interface
lldp-agent
(disable|enable|rx-
only|tx-only)
This command configures the LLDP agent function.
disable – Disable the LLDP on the specific port.
enable – Transmit and Receive the LLDP packet on
the specific port.
tx-only – Transmit the LLDP packet on the specific
port only.
rx-only – Receive the LLDP packet on the specific
port.
configure
interface range
gigabitethernet1/0/
PORTLISTS
This command enters the interface configure
node.
Web Configuration
Management > Device Management > Link Layer Discovery Protocol (LLDP)
Parameter
Description
State
Globally enables / disables the LLDP on the Switch.