User's Manual
Table Of Contents
- Product Overview
- Router Setup
- Basic Router Settings
- Wireless Networking and Security
- Advanced Router Settings
- Change your router login password
- Manually configure your Internet connection
- IPv6 Settings
- Clone a MAC address
- Change your router IP address
- Set up the DHCP server on your router
- Set up DHCP reservation
- Enable/disable UPnP on your router
- Enable/disable Application Layer Gateways (ALG)
- Allow/deny multicast streaming
- Identify your network on the Internet
- Set your router date and time
- Create schedules
- Access Control (IP Protocol Filter)
- Inbound Filter
- Open a device on your network to the Internet
- Virtual Server
- Allow remote access to your router management page
- Using External USB Storage
- Virtual Private Networking (VPN)
- Router Maintenance & Monitoring
- Reset your router to factory defaults
- Router Default Settings
- Backup and restore your router configuration settings
- Reboot your router
- Upgrade your router firmware
- Allow/deny ping requests to your router from the Internet
- How to capture network packets
- Diagnostic Tools
- Ping Watchdog
- Auto Reboot
- Wireless Client List
- Check the router system information
- View your router log
- Router Management Page Structure
- Technical Specifications
- Appendix
© Copyright 2017 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-827DRU
65
Check the router system information
Advanced > Administrator > Status
You may want to check the system information of your router such as WAN (Internet)
connectivity, wireless and wired network settings, router MAC address, and firmware
version.
1. Log into your router management page (see “
Access your router management page”
on page 10).
2. Click on Advanced and click on Administrator, then click on Status
System Information
Firmware Version – The current firmware version your router is running.
Time: The current time set on your router.
System Up Time – The duration your router has been running continuously
without a restart/power cycle (hard or soft reboot) or reset.
Internet Configuration
Connected Type: Displays the current WAN connection type applied.
WAN IP Address – The current IP address assigned to your router WAN port or
interface configuration.
WAN MAC Address: Displays the current WAN MAC address.
Subnet Mask - The current subnet mask assigned to your router WAN port or
interface configuration.
Default Gateway – The current gateway assigned to your router WAN port or
interface configuration.
Primary/Secondary DNS (Domain Name System) Server – The current DNS
address(es) assigned to your router port or interface configuration.
DHCP WAN Type: These buttons will be available in DHCP WAN type only.
o Renew: Click this option to renew your WAN IP address.
o Release: Click this option to release the WAN IP address of your
router.
PPPoE WAN Type: These buttons will be available in DHCP WAN type only.
o Connect: Click this option to connect to your DSL ISP
o Disconnect: Click this option to disconnect from your DSL ISP.