User's Manual
Table Of Contents
- Product Overview
- Router Setup
- Basic Router Settings
- Wireless Networking and Security
- Advanced Router Settings
- Change your router login password
- Manually configure your Internet connection
- IPv6 Settings
- Clone a MAC address
- Change your router IP address
- Set up the DHCP server on your router
- Set up DHCP reservation
- Enable/disable UPnP on your router
- Enable/disable Application Layer Gateways (ALG)
- Allow/deny multicast streaming
- Identify your network on the Internet
- Set your router date and time
- Create schedules
- Access Control (IP Protocol Filter)
- Inbound Filter
- Open a device on your network to the Internet
- Virtual Server
- Allow remote access to your router management page
- Using External USB Storage
- Virtual Private Networking (VPN)
- Router Maintenance & Monitoring
- Reset your router to factory defaults
- Router Default Settings
- Backup and restore your router configuration settings
- Reboot your router
- Upgrade your router firmware
- Allow/deny ping requests to your router from the Internet
- How to capture network packets
- Diagnostic Tools
- Ping Watchdog
- Auto Reboot
- Wireless Client List
- Check the router system information
- View your router log
- Router Management Page Structure
- Technical Specifications
- Appendix
© Copyright 2017 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-827DRU
61
Manual Firmware Upgrade
1. If a firmware upgrade is available, check the router model on our website
http://www.trendnet.com/support and download the firmware to your computer.
2. Unzip the file to a folder on your computer.
Please note the following:
Do not interrupt the firmware upgrade process. Do not turn off the device or
press the Reset button during the upgrade.
If you are upgrade the firmware using a laptop computer, ensure that the laptop
is connected to a power source or ensure that the battery is fully charged.
Disable sleep mode on your computer as this may interrupt the firmware upgrade
process.
Do not upgrade the firmware using a wireless connection, only using a wired
network connection.
Any interruptions during the firmware upgrade process may permanently
damage your router.
1. Log into your router management page (see “
Access your router management page”
on page 10).
2. Click on Advanced and click Setup, then click Firmware.
3. Depending on your web browser, in the Upload Firmware section, click Browse or
Choose File.
4. Navigate to the folder on your computer where the unzipped firmware file (.bin) is
located and select it.
5. Click Apply. If prompted, click Yes or OK.