User's Manual
Table Of Contents
- Product Overview
- Router Setup
- Basic Router Settings
- Wireless Networking and Security
- Advanced Router Settings
- Change your router login password
- Manually configure your Internet connection
- IPv6 Settings
- Clone a MAC address
- Change your router IP address
- Set up the DHCP server on your router
- Set up DHCP reservation
- Enable/disable UPnP on your router
- Enable/disable Application Layer Gateways (ALG)
- Allow/deny multicast streaming
- Identify your network on the Internet
- Set your router date and time
- Create schedules
- Access Control (IP Protocol Filter)
- Inbound Filter
- Open a device on your network to the Internet
- Virtual Server
- Allow remote access to your router management page
- Using External USB Storage
- Virtual Private Networking (VPN)
- Router Maintenance & Monitoring
- Reset your router to factory defaults
- Router Default Settings
- Backup and restore your router configuration settings
- Reboot your router
- Upgrade your router firmware
- Allow/deny ping requests to your router from the Internet
- How to capture network packets
- Diagnostic Tools
- Ping Watchdog
- Auto Reboot
- Wireless Client List
- Check the router system information
- View your router log
- Router Management Page Structure
- Technical Specifications
- Appendix
© Copyright 2017 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-827DRU
31
Advanced Router Settings
Change your router login password
Advanced > Setup > Management
1. Log into your router management page (see “Access your router management page”
on page 10).
2. Click on Advanced and click on Setup, then click on Management.
3. Under the Administrator Settings section, in the Password field.
Note: The idle timeout setting is used to define the period of inactivity in the router
management page before automatically logging out.
4. To save changes to this section, click Apply when finished. Commit your changes to
the router by clicking on Apply/Discard Changes in the left-hand menu, and click Apply
& Reboot.
Note: If you change the router login password, you will need to access the router
management page using the User Name “admin” and the new password instead of the
predefined default password. If you reset the device to defaults, you will need to access
the router management page use the predefined settings on the side or bottom labels.
Manually configure your Internet connection
Advanced > Setup > WAN Settings
1. Log into your router management page (see “Access your router management page”
on page 10).
2. Click on Advanced and click on Setup, then click on WAN Settings.
3. Under Internet Connection Type in drop-down list, select the type of Internet
connection provided by your Internet Service Provider (ISP).
4. Complete the fields required by your ISP.
5. Complete the optional settings only if required by your ISP.
6. To save changes to this section, click Save when finished. Commit your changes to the
router by clicking on Apply/Discard Changes in the left-hand menu, and click Apply &
Reboot.
Note: If you are unsure which Internet connection type you are using, please contact
your ISP.