User's Manual
Table Of Contents
- Product Overview
- Router Setup
- Basic Router Settings
- Wireless Networking and Security
- Advanced Router Settings
- Change your router login password
- Manually configure your Internet connection
- IPv6 Settings
- Clone a MAC address
- Change your router IP address
- Set up the DHCP server on your router
- Set up DHCP reservation
- Enable/disable UPnP on your router
- Enable/disable Application Layer Gateways (ALG)
- Allow/deny multicast streaming
- Identify your network on the Internet
- Set your router date and time
- Create schedules
- Access Control (IP Protocol Filter)
- Inbound Filter
- Open a device on your network to the Internet
- Virtual Server
- Allow remote access to your router management page
- Using External USB Storage
- Virtual Private Networking (VPN)
- Router Maintenance & Monitoring
- Reset your router to factory defaults
- Router Default Settings
- Backup and restore your router configuration settings
- Reboot your router
- Upgrade your router firmware
- Allow/deny ping requests to your router from the Internet
- How to capture network packets
- Diagnostic Tools
- Ping Watchdog
- Auto Reboot
- Wireless Client List
- Check the router system information
- View your router log
- Router Management Page Structure
- Technical Specifications
- Appendix
© Copyright 2017 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-827DRU
24
Please refer to page 18 to find out about different security types and page 19 for
wireless security configuration.
The diagram shows an example of a client connecting to SSID 1 and another client
connecting to SSID 2.
5. To save changes to this section, click Save when finished. Commit your changes to the
router by clicking on Apply/Discard Changes in the left-hand menu, and click Apply &
Reboot.
Note: You can repeat the steps to enable and configure additional SSIDs.
Wireless bridging using WDS (Wireless Distribution System)
Advanced > Wireless (2.4GHz or 5GHz) > WDS
Wireless bridging using WDS allows the device to create a wireless bridge with other
WDS supported wireless routers and access points configured in WDS mode to bridge
groups of network devices together wirelessly. Simultaneously, the router will also
function in access point mode allowing wireless client devices such as computers, game
consoles, mobile phones, etc. to connect in order to access network resources from
multiple groups of network devices as well as the Internet.
Note: You can create up to four WDS bridge connections on each wireless band (2.4GHz
and 5GHz. WDS (Wireless Distribution System) is not currently standardized and may not
connect to different model wireless routers or access points, therefore, when using WDS,
it is recommended to use the same model and version for wireless bridging.
By default, your router functions in Access Point mode to allow wireless client devices to
connect and access your network resources and access the Internet.
The diagram below shows your router in Access Point mode and clients connecting to
your router.