User's Manual
Table Of Contents
- Product Overview
- Router Setup
- Basic Router Settings
- Wireless Networking and Security
- Advanced Router Settings
- Change your router login password
- Manually configure your Internet connection
- IPv6 Settings
- Clone a MAC address
- Change your router IP address
- Set up the DHCP server on your router
- Set up DHCP reservation
- Enable/disable UPnP on your router
- Enable/disable Application Layer Gateways (ALG)
- Allow/deny multicast streaming
- Identify your network on the Internet
- Set your router date and time
- Create schedules
- Access Control (IP Protocol Filter)
- Inbound Filter
- Open a device on your network to the Internet
- Virtual Server
- Allow remote access to your router management page
- Using External USB Storage
- Virtual Private Networking (VPN)
- Router Maintenance & Monitoring
- Reset your router to factory defaults
- Router Default Settings
- Backup and restore your router configuration settings
- Reboot your router
- Upgrade your router firmware
- Allow/deny ping requests to your router from the Internet
- How to capture network packets
- Diagnostic Tools
- Ping Watchdog
- Auto Reboot
- Wireless Client List
- Check the router system information
- View your router log
- Router Management Page Structure
- Technical Specifications
- Appendix
© Copyright 2017 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-827DRU
7
Hardware Installation
1. Attach the antennas to the router and position them for the best WiFi coverage. It is
recommended that you position all of the antennas vertically as shown below.
2. Verify that you have an Internet connection when connecting your computer directly
to your modem.
3. Turn off your modem.
4. Disconnect the Network cable from your computer to your modem.
Note: If your modem includes a battery backup, remove the battery backup as well.
5. Connect your modem to the router Internet port (yellow).
6. Connect your computer to one of the router LAN ports (black).
7. Connect the power adapter to the router and then to a power outlet. Push the power
on the back of the router to the On (Inner) position.
8. Turn on your modem.
9. Verify that the blue LEDs on the front of the router (Power, Internet, 2.4G, 5G) and
port number of your connected computer (1, 2, 3, or 4) are on.