User's Guide
Table Of Contents
- Product Overview
- Getting Started
- Initial Setup
- Status
- System
- Wireless Networking and Security
- General Configuration
- Access Point
- Client Bridge
- WDS
- Repeater
- Management
- Administration
- Administrator Settings:
- Device Name Settings:
- Management VLAN
- SNMP Settings
- Backup/Restore Settings
- Export Settings (backup your configuration):
- Import Settings (restore from configuration):
- Reset to Factory Defaults
- System Reboot:
- Time and Date Settings
- Automatically set using NTP:
- Daylight Saving Time:
- NTP Settings:
- Date and Time Settings (manually set):
- SSH Management
- Log
- Diagnostics
- Ping Test Parameter:
- Traceroute Parameter:
- Download Technical Support Data:
- LED Control
- AP utility
- Technical Specifications
- Troubleshooting
- Appendix
© Copyright 2018 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-826DAP
5
Basic Setup
Note: It is strongly recommended to configure the access point first before mounting.
For a typical wireless setup at home or office when using the access point in AP mode,
please do the following:
1. Connect the power adapter to the power port of the access point. Or simply
plug an Ethernet cable on the access point to a PoE+ (Power over Ethernet+)
switch that connects to your router or network.
a. If using the power adapter, plug an Ethernet cable to either LAN1 or
LAN2 on the access point and plug the other end to your access point
or network, and then depress the Power button
2. The PWR, 5GHz1, 5GHz2, 2.4GHz, and the LAN (whichever is used to connect to
the network) LEDs will all turn on to indicate that the access point is ready.
3. For your security, each TEW-826DAP comes pre-encrypted with a unique WiFi
Name (SSID) and WiFi Password. You can find your device's SSID and WiFi
password on the white labels located on the device. Use this information to
connect to the TEW-826DAP access point.
4. Verify your connection to you network by accessing the Internet. For advanced
configuration continue to the advanced sections of the user manual. (see
“Access the management page” on page 8)